![]() ![]() So, it shouldn’t happen- but apparently, can happen if the chip reset contacts touch metal when being removed/reinserted- so, keep an eye on the physical ink level to avoid running any carts empty. I then removed the PK cart again, this time by wiggling it slightly (instead of lifting straight up, as I previously did)- apparently, during the wiggly removal of the cart caused the chip sensor (I assume?) to touch the chip reset contacts, and reset the chip- because after reinserting, the PK read full. See Updating the printer driver information. Finally, select the correct ink cartridge in the printer driver according to the actual ink cartridge installed in the printer. Two carts reset to full, but the others remained at the level before they were removed. Stop printing, and then press and hold the Pause button for 3 seconds. MAKE SURE YOU DO NOT TAKE INK CARTRIDGE OUT. 3) Lift the Gray Clamp that holds the ink cartridge all the way open then clamp it back down. The Epson Stylus R3000 is a great printer for the modern artist who needs to be able to print on a wide variety of media and needs to maintain a high level of detail. ![]() 2) The print head will move to left to cartridge installation position. I removed and reinserted all the carts, then checked the ink level readings on the printer’s LCD panel. 1) Pause the printer, hold down the Load/Eject button for 6 seconds power light will blink. When I turned the printer on, all the carts were reading the same level- just under 1/2 full. I just did some tests with our R3000 and set of refillable carts that have been installed (it’s resting with PiezoFlush, as we haven’t needed to use it in a while). The SP2100 set a new benchmark for digital photo printing. Many photographers were now ready to move out of the darkroom and fully embrace digital photography. The SP2100 was an instant success due to its use of long lasting UltraChrome pigment inks which claimed a life of 200+ years. In my experience, the R3000 carts I have tested only reset the ink levels when the two reset contacts are touched with a pair of tweezers, but if the points are touched by the chip sensor or other metal, this could also cause the chip to reset. It's now almost 10 years since Epson launched the Stylus Photo 2100.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |